Engines: Mercury - Mariner - Johnson - Suzuki - Honda - OMC - Yamaha - Tohatsu
Telescopic tube from mm.360 mm.770 in light alloy, to adapt to the various heights from the ground of the outlet to the sea.
Fork plastic-coated steel with suction cups, round, rubber, model with influx of water from a side.
Made of polymer polypropylene, black. Apply to the plate anticavitation valves with the 4 bolts and nuts (included). For engines from 8 to 40 HP.
Made of polymer polypropylene, black. Apply to the plate anticavitation valves with the 4 bolts and nuts (included). For motors over 40 HP.
Made of polymer polypropylene, black. Mounting without drilling the plate anticavitazionale. For motors over 40 HP.
To install SE Sport 200/300 without drilling the plate anti-cavitation. You install on all outboard motors and sterndrives except the following models: all Volvo, Mercury 50HP 2 STROKE, Mercury 40-50-60 HP 4-STROKE, Mercury Bravo III and II (it's also good on the Bravo III with two anodes below the plate of cavitation), Honda 200/225.
Made in stainless steel mirror polished.
The white plastic.
Manufactured in marine plywood multilayer. Equipped with screws and tube for the application on the stern pulpit. It is suitable for tubes Ø mm.22/25. NOTE: it Is recommended to always connect the motor with the cable yet.
Built in aluminium alloy 6061 T6 and screws are stainless steel. Thanks to its high lifting capacity is indicated for all engines 3/4/6 cylinders, has no problems, in fact, to even lift a V6 300HP at full throttle. Complete with position indicator and control panel. The tank, pipes and hydraulic pump are contained within it.
Fork plastic-coated steel with suction cups, round, rubber.
Stabilizer/provider of new generation which represents the maximum evolution of this type. Designed for boats and inflatable boats up to 6 m.