The handle and the stainless steel spokes-coated in soft polyurethane.
Equipped with clutch. Employs two-wire M58. Configuration on the laws and regulations ABYC. Built in materials resistant to marine corrosion. Clutch series externally adjustable. Installation 90° with hubcap black. The group wheelhouse can be fitted in 4 different positions to allow the cable to exit in the direction most convenient for you.
The hub and the rim are made of brass. Painted with polyurethane varnish, glossy transparent.
Crown five-spoke polished stainless steel covered in polyurethane.
His unique system of the folding, quick allows you to retrieve the available space in the cockpit.It is ideal for a wide range of yachts, including those with dual wheel. The wheel folding closes on the same occupying less than half of the space.
Can be installed on any wheelhouse Lewmar and allows you to lock the rudder.
Allows you to quickly remove the wheel from the bollard with just the action of a crank winch. Made of stainless steel 316, mirror polished
Designed for the wheels of the rudder with conical hubs or parallel 1”. Can be used on most vessels to attach the steering wheel to the pulpit after removing it from the column.
Control type motor, non-magnetic, so it can be mounted on pedestal or bulkhead without interfering with the compass.
With button plug neutral parts and the relative pin.
Created through a collaboration with shipyards in order to improve the operation of the autopilot and to facilitate the installation.
Suitable for all timonerie.
Kit of 2 curves 90°, is ideal when it is very little side space to the entrance of the tubes.
For engines Yamaha 20C, 20D, 20V, 25D, 30A and 30G.
Aluminum plate painted black for the transom full support, and tube for fixing the cable steering.
Plate save the stern in anodized aluminum painted black.
Only support tube to be fixed to the transom or to the plate.