This charge controller is used in solar plants of small dimensions for the controlled charge two batteries, liquid electrolyte or gel.
Frame to be fixed only in the central part of the Roll Bar, universal model. Full support to mount lights on. Dimensions frame 1100x180 mm. Complete with 4 m cable to solar power. Roll Bar not included in the price.
Allows the control of temperature, short-circuit protection, over-voltage, reverse polarity protection. Disconnects the output in case of low voltage loads in three stages: BULK, ABSORPTION, FLOAT. The DUO version allows you to load 2 batteries at the same time, and schedule the charge for each battery.
Produces electrical power at 12 or 24V. Casing in anodised aluminium and stainless steel. The blades are of nylon reinforced with glass fibre. Engine locking device in the "OFF"position.
Pair of connectors, male - to-female for the installation of the panels Enecom. Allow, attaching them to the cables of the board, the immediate connection to the Enecom, already equipped with the respective connectors MC4.
Manufactured with solar cells, aerospace, high-performance. Are panels the latest generation of ultra-thin, only 1.7 mm, and ultraflessibili. Efficiency cells mono 17,25%. The panel consists of a sandwich formed by a plastic support + solar cell + surface coating resin epoxy UV resistant.
Equipped with terminals that are adaptable to widths of 1200-1500 mm. It can be paired with any T-Top in the trade manufactured with tubes Ø 28/44 mm. Dimensions panel chassis 1150x320 mm.
With two batteries.